![]() Zone temperature, hold time, active or not.If you click on the save button, you can edit the profile in the profile editing menu.These profiles can also be used as template to specify your own curve. In this window you can see the 9 predefined soldering profiles. We deliver the eC-reflow-pilot software including some predefined solder profiles.Due to the double level built drawer, the PCB will not move as it sits on the top level of the drawer, if the drawer is opened while using the hood. Setting the door open point at 215☌ will make sure that the oven opens up fast enough so cooling can take place quicker. ![]() The set dwell time of 10 seconds will exceed 30 seconds, which should be enough for any standard technique. To be sure of the latter, you could still activate T ramp, but that usually has no effect because the oven is slower than the built in security value of not reaching 190☌ within 3 minutes. ![]() Due to the enormously good thermal insulated eC-reflow-mate-V4, the effect of the Thermal Inertia, will make sure that heat up times are well under the maximum defined ramp up times. This curve will take the board straight to the reflow temperature and hold it for at least 10 seconds.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |